About The Characteristics Of Single Cylinder Circular Socks Machine
The single-cylinder circular hosiery machine is a hosiery machine that knits long, medium, short socks and pantyhose with one needle cylinder. It can produce socks of various mechanisms such as plain stitch, plated yarn, tuck, jacquard, terry and bar. The key loop forming parts are latch needles, sinkers, foot pieces and jacquard pieces. There are long, medium and short butts of latch needles. Generally, long butt needles and short butt needles are equipped on the half circle of the needle tube. The latch needle moves left and right in the groove body of the needle cylinder to develop the weaving. The sinker is located in the middle of the latch needle and is used for tangential entry and exit. Its function is to grasp the electromagnetic coil when it is blocked, and stretch the electromagnetic coil after forming a circle. When forming a coil, the length of the electromagnetic coil is determined by the distance between the needle tube and the plan view above the settlement. The foot piece can transmit the movement to the latch needle, and the jacquard piece has multiple levels of teeth for further needle selection.
After needle selection, latch needles operate in different lines to determine whether they are involved in knitting. The upper and middle triangles and the upper and lower yarn bending triangles of the triangle system of the circular sock machine are symmetrical triangle seats, so the needle tube can be knitted when it is unilaterally or double-rotated. The effect of the jacquard sheet is on the butt of the large jacquard sheet, which can make the latch needle rise to the relative height of being blocked, pass over the right bending triangle, press down through the upper and middle triangle, and wind the cotton yarn, and then bend the yarn along the left Triangular lowering produces a new solenoid, taking off the old solenoid, and raising it along the panel to generate a solenoid. If the jacquard piece is pushed by the needle selection organization to the needle tube groove body, it will not rise along the jacquard triangle, and then the latch needle will operate at the lower position, and there will be no threading or looping at this time.
The characteristic of the round sock machine is that it can double-pack the bag-shaped heel and toe. Weaving the heel and toe of the socks is carried out by the needle picker and the presser in the same way. When the sock heel is gradually knitted, first stop the sock knitting needle from working. At this time, the needle tube turns into a double rotation, and the upper and lower needle pickers are replaced to enter the work. Select above the upper middle triangle to make it withdraw from work. This is the whole process of narrowing. After receiving the corresponding knitting number, the needle presser enters the work, so that the knitting needles in the work are lifted and withdrawn and then gradually participate in the weaving, which is the whole process of needle setting. When releasing the needle, every time the needle presser presses two stitches, the needle picker still picks one stitch, so that the number of knitting needles involved in the operation is gradually increased. After the needle is placed, the heel of the sock is produced. The toe can also be knitted in the above way, but the closed toe can be sutured in the professional process, or it can be sewed immediately on the hosiery machine, or other forms such as knots and heat fusion can be used.
When weaving some long and medium socks, a sock hook is installed on the disc groove above the needle tube. The sock hook moves in and out tangentially. The hook on the front side is wrapped around the electromagnetic coil and retracted to make the coil. Hide, when the single-sided sock is knitted to a sufficient length and folded into the required two layers, the sock hook is displaced, and the electromagnetic coil will start to migrate to the latch needle and the two-layer sock will be converted. The behavior of the knitting needles when opening and folding is carried out by another cam system.
